Avisaro Online Documentation - Wiki
Impressum Kontakt Sitemap

WAGO connector for RS232 interface

2x RS232

The Avisaro 2x RS232 Box comes with two RS232 ports. The first port (Port 1) is the primary one (able to receive commands) and comes fully equipped with hardware flow control signals. The second port (Port 2) is the auxiliary one.

WAGO

WAGO Connector

1.) Clear To Send (CTS): Client is ready to receive data
2.) Request To Send (RTS) Avisaro wants to send data
3.) Receive (RxD) Data going to Avisaro Box
4.) Transmit (TxD) Data going to device
5.) Supply voltage (6 - 32 V)

6.) Supply and Signal Ground (GND)

(RTS / CTS for port 1 only)
WAGO



Cable are connected with the WAGO 734 series connectors. In most product configurations, those adapters are shipped with the box. Check the 'scope of delivery' list. Details to the connectors are found Mehr here.

RS232 D-Sub to WAGO adapter

Standard SubD-9 connector (male)

RS232 SubD
1.) Data Carrier Detect (DCD)
2.) Receive (RxD) Data going to Avisaro Box
3.) Transmit (TxD) Data going to device
4.) Data Terminal Ready (DTR) Avisaro Box is up
5.) Signal Ground GND
6.) Data Set Ready (DSR) Client is up and running
7.) Request To Send (RTS) Avisaro wants to send data
8.) Clear To Send (CTS) Client is ready to receive data
9.) Not used (Ring Indicator (RI)
 
(RTS / CTS for port 1 only)
WAGO - SubD Adapter



The SubD connector is realised using a WAGO to SubD adapter. This adapter is usually shipped with the box - check 'scrope of delivery'. Details on the adapter can be found Mehr here.

WAGO - SubD Adapter
 
Barrel


The barrel connector on the WAGO-SubD adapter is layouted as follows. Supply voltage is 6 - 32 V. '
Diameter of the connector is 2.1mm.