Integration into a Wifi Infrastructure

You probably have started your configuration with an Adhoc-Conntection to the device. Using the Web-Administration Page you can modify all parameters necessary it integrate your Avisaro Device into an existing Wifi Infrastructure.

To do so you need all data of your Access Point that is running the infrastructure: 

• SSID
• IP Area
• Methode of Encryption
• Password

Then continue as follows:

Wifi Parameter

First change the Wifi parameter fitting to you infrastructure:

• SSID: Enter the network name of your infrastruture
• Mode: Select mode infrastructure
• Encryption: Select your password type (be sure that this is the right one - especially by choosing WPA and WPA2)
• WEP Key / WPA Phrase: Enter the code (WEP in Hex, WPA as phrase - pay attention to not accidently add a space before or after). Using WEP ignore the WPA field - and vice versa. Using WEP 40: the Page might enter additional letter by itself - this is for security reasons - please ignore this.
• Press SUBMIT after changing the parameters.

Please pay attention to the correct spelling of your password including capital letter. Any mistake will not allow you to have contact to your Avisaro device later on.

For details you the Administrator Page see here.

IP Address and Gateway

Change the IP adress and Gateway reffering to your infrastructre:

• Enter a IP adress that fits to your network IP area
• Enter the Subnet Mask. Working with a standard Access Point setup in most cases it will be 255.255.255.0
• Enter the Gateway / DNS according to the Wifi network. Working with a standard Access Point Setup both will be ... . ... . ... . 1
•  Press SUBMIT

For details you the Administrator Page see here.

Rebooting

Make sure that all parameter are set correctly. Now goto 'General' and reboot the device. Afterwards you can enter use the device or enter the Administrator-Page via your infrastructure.