Power Up Avisaro 2.0 "Cube"

The Avisaro 2.0 "Cube" products are powered with a DC voltage of 6V - 32V.

Use the power supply shipped with the product, a 12V or 24V supply of a car or a truck or any other suitable source. The WLAN products require about 1W, the Logger products about 0.5W of power.

The position of the power pins at the screw type termina is the same for RS232, CAN or any other interface.

Screw Type Terminal

1. Signal Ground (GND)
2. Internal use ^(*)
3. Clear To Send (CTS): Client is ready
4. Request To Send (RTS): Avisaro has data
5. Receive (RxD) Data going to Avisaro Box
6. Transmit (TxD) Data going to device
7. Supply Voltage (6-32V)
8. Supply Ground (GND)

^(*) This pin provides 5V power supply to power sensors placed inside the Cube