Power Up Avisaro 2.0 - Module

The module is made to be placed on the board. It needs an environment of the interface and a voltage regulator. As such the  Avisaro Connector Boards are available.

The Avisaro 2.0 Modules are powered with a DC voltage of 3.3 V.

The Logger modules draw about 80mA and the WLAN modules draw about 290 mA in non-power save mode.

The position of the VCC (3.3V) and Ground signals are the same independent from the configured interface (here RS232).

Pin 1 Orientation

Pin 1 of the Avisaro 2.0 module is in the top left corner. Pin numbering is counting counterclockwise.

PIN Layout

To connect the module select the layout according to the interfaces needed.

For the layouts see  here.