Reset to default via I/O pins

By shortening two pins, the Avisaro 2.0 device can be reset to default values. 

This option is available since firmware version 4.66 - typically in products shipped after February 2010.

The procedure is:

1. Disconnect power from the Avisaro device. The Avisaro Module must be accessible - if you have a "Box" or "Cube" unscrew the lid to gain access.
2. The Pins to shorten are "Internal MISO" (Pin 17) and "Internatl MOSI" (Pin 18). Use a suitable flex cable or, in a pinch, a paperclip.
3. Reconnect power.
4. Disconnect the pin 17/18 connection (leaving power connected). That's it.

Now - the Avisaro 2.0 device operates with default settings. Please note: the device is back on RS232 as a default interface - if you use CAN interface this needs to be reconfigured.