WPS

Description

The WPS command starts the process to automatically receive Wi-Fi configuration data. WPS is a standard automatic configuration procedure supported by many Access Point.

Parameters

There is only one parameter:

WPS START
Starts the WPS procedure. Usually, a button has to be pushed on the Access Point to enable WPS mode for 2 minutes. Afterwards, the 'WPS START' command has to be issued on the Avisaro WLAN Device.

The command is blocking. It takes about 15 seconds for the Avisaro Module to negotiate the parameters. 

Return Value

ERR_OK (0) if the command was accepted.
ERR_NET(39) net is down = no WPS Access Point in sight.

Example

WPS START

This starts the configuration process.

Remarks

When using WPS, it usually makes sense to use also the "DHCP CLIENT" setting.